The Mauch Power Module for PixHawk and ArduPilot is a simple way of providing your APM with clean power from a LiPo battery together with a BEC as well as current consumption and battery voltage measurements, all through a 6-pos cable.

It is compatible with miscellaneous flight controllers including Pixhawk, APM and their variants.

Thanks to its high quality of manufacturing, it allows to avoid overheating and power loss issues. Based on Allegro Hall ACS758-050U sensor, it is a highly precise sensor with an incredible accuracy.

All Mauch power modules have a serial number and have been subject to quality control.

Warning: Have a close look at inter-compatibility between selected MAUCH products (see below).

• Max current sensing: 50A
• Voltage range: up to 20S (85V) with solder bridge open (up to 7S with solder bridge closed)
• Power cable: 2x 12AWG of 10 cm
• Size and weight (without protection): 27.5 x 19.5 x 10.5 mm / 17g
• Size and weight (with protection): 43.5 x 23 x 15 mm / 22g

• 1 x Mauch Power module (and its CFK cover)

• Pixhawk installation
• Manual

• Mauch BECs for PL power modules:
  • 2-6S 1x 5,35V
  • 2-6S 2x 5,35V
  • 2-6S 2x 5,35V / 1x 12V
  • 4-14S 1x 5,3V
  • 4-14S 2x 5,3V
  • 4-14S 2x 5,3V / 1x 5V
  • 4-14S 2x 5,3V / 1x 12V
  • 4-14S 2x 5,3V / 1x 5V / 1x 12V

• Sensor Hub X2-V2

• Connector is of the following type: Molex / Click-Mate / 1.25mm / 4p (5023800400)
• This power module can be directly plugged to a Premium-Line (PL) BEC or to the Sensor Hub X2-V2
• The power module comes without sensor cable as it is delivered together with the BEC
• If you want to use you own BEC, you will need to purchase a sensor cable and to make sure that this BEC supplies a voltage within 4.95 and 5.05 Volts