This sensor hub allows to connect two PixHawk Mauch current sensors in parallel in order to add their current capacities.

The current of both sensors is summarized before reaching the flight controller while the voltage measurement of the LiPo packs are collected from both sensors and passed through the hub to the flight controller.

The main purpose of this hub is to replace existing protection circuits and to monitor that both paralleled LiPos are supplying the same current to the system.

Thanks to Mauch Sensor Hub X2, you can spot early when a LiPo starts to fail, way before this situation is irreversible.

In case of difference in current:

• Larger than +/- 10% => the Hub will issue a warning to the pilot via a power LED and/or buzzer connected to the alarm output.
• Larger than +/- 20% => the alarm output will remain ON to indicate the fault meaning the pilot should land immediately and check the batteries

Additionally, a reserve relay contact (alarm) is available allowing you to implement any desired function.

Warning: Have a close look at inter-compatibility between selected MAUCH products (see below).

• Size: 39 x 31 x 6 mm
• Weight (without cables): 7g

• 1 x Mauch Sensor Hub X2
• 1 x 6-pos DF13 cable of 10 cm for flight controller
• 2 x 6-pos to 4-pos DF13 cables of 10 cm

• Manual
• Mauch power sensors for PixHawk
• Mauch BEC voltage regulators for PixHawk
• DF-13 - 6 position wires for power module

Required for a complete setup:

• 1 x Mauch Sensor Hub X2
• 2 x Mauch power sensors for PixHawk
• 1 x Mauch BEC voltage regulators for PixHawk