The L12-R series of small linear servos operate as a direct replacement for standard rotary servos. They use the same standard 3 wire connector, ground power and control.

Regardless of how you drive your servos, either with an RC receiver, an Arduino board or a VEX micro-controller, the L12-R servo will function in place of a regular servo while providing the linear motion benefit.

These actuators are built to last and give a nice design on your models.

• Manufacturer: Actuonix (previously Firgelli)
• Model: L12-100-100-6-R
• Gearing (100:1)
  • Peak power point: 31N @ 7 mm/s
  • Peak efficiency point: 17N @ 10 mm/s
  • Max speed (no load): 13 mm/s
  • Max force (lifted): 42N
  • Back drive force (static): 22N
• Stroke (100mm)
  • Mass: 56 g
  • Repeatability: ~0.5 mm
  • Max side load (extended): 15N
  • Closed length: 152 mm
  • Potentiometer: 11k‎Ω~50%
• Voltage (DC 6V)
  • Max input voltage: 7.5V
  • Stall current: 460mA
  • Standby current: 7.2mA
• Operating temperature: -10°C to +50°C
• Potentiometer Linearity: less than 2.00%
• Max duty cycle: 20%
• Audible noise: 55dB @ 45cm
• Ingress protection: IP-54
• Mechanical backlash: 0.2 mm
• Limit switches: max current leakage: 8uA
• Maximum static force: 200N

• 1 x Linear servo
• 1 x Screws and others set

• The L12-R will not operate with Futaba receivers like the R6014FS that output 2.7 volts. You will need a Smart Fly Power Expander or Orbit Power Jack to bring the signal level up to 5vdc for the L12-R to operate.