Dualsky programmable brushless high quality Xcontroller.

• Current: 30A (40A in peak)
• High modulation rate PWM (10 KHz)
• Refresh rate: from 50 to 400Hz
• Up to 12 NiCd or Ni-MH cells and from 2 to 4 LiPo cells
• BEC (1.5A) to power the receiver
• Thermal protection
• Easily programable
• Undervoltage protection -> the cutting value can be modified
• The minimum value can be programed for motor shutting-off or for low RPM mode
• Break activating/desactivating possibility
• Optimised advance timing
• Secured activation elimination an eventual accidental motor start
• Soft startup allows to avoid mechanical overload
• Automating shut-off 4 seconds after signal missing/bad signal
• Controlled by microprocessor of the most advanced technology
• Possibility to change the rotation direction without disconnecting
• Weight: 22 gr
• Approx. dim (excl. cables): 5.8 x 2.4 x 0.6 thick

• 1 Controller

• This electronic speed controller doesn't supports the I²C BUS and cannot be used on a MikroKopter setup, except if it is connected through our I2C-2-PWM converter.