Carrier board for The Cube (Pixhawk 2.1) with ADSB receiver

This carrier board is designed to receive any Cube (Cube Black, Cube Orange, Cube Yellow, Cube Purple) thanks to its standardized DF17 connector.

This interface allows to connect multiple accessories to a Cube like GPS receivers, distance sensors (LiDAR, sonars, etc.) or any equipment communicating in Mavlink (Gremsy gimbal, FLIR camera, etc.).

The biggest highlight of this carrier board is that it embeds a uAvionix 1090MHz ADSB IN receiver. Thanks to it, your drone will receive incoming signal from aircraft (speed, altitude, position, etc.) on this frequency. It is the same signal used by website tracking commercial aircraft like FlightRadar or FlightAware. This information can be displayed on telemetry or directly used by the drone for automated avoidance (anti-collision).

Connectivity

• 2x Power plugs for redundant power supply of Cube and carrier board
• 4x Serial port to configure
• 1x ADS-B 1090MHz receiver connected to Serial5
• 1x I2C port
• 2x CAN BUS ports
• 1x USB port
• 1x ADC port
• 14x Servo outputs
• 1x Spektrum Rx dedicated port
• 1x Futaba SBUS output
• 1x PPM input
• etc.

• ADS-B receiver: 1090 MHz
• Size: 94 x 44 x 18 mm
• Weight (approx.): 45 gr

• 1x ADSB carrier board

• Configure ADSB carrier board
• Cube Black
• Cube Orange